Overview
Designed as a drop-in replacement for Remington 091375-02S 114736-01S Chainsaw models, this chain restores your saw’s cutting ability to like-new condition. Ships as a 2-piece set, giving you a ready spare. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 16”
- Quantity: 2 chains per pack
Compatibility
Fits Remington 091375-02S 114736-01S Chainsaw as a direct replacement for the factory chain. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Turn off the chainsaw and remove its power source before servicing. Unscrew the bar cover, back off the tensioner, and pull the old chain free. Route the fresh chain around the clutch drum and into the bar groove, making sure the drive links seat properly. Tighten the tensioner until the chain snaps snugly against the underside of the bar but still slides freely, then run the saw briefly at idle to confirm smooth tracking.
Common questions
Q: Will this 2-pack 16-inch chain fit my Remington 091375-02S or 114736-01S chainsaw without modification?
Yes, this replacement chain set is made for Remington 091375-02S and 114736-01S chainsaws with a 16-inch bar. As long as your saw is using the original 16-inch setup, these chains should install normally on the existing bar and sprocket.
Q: Do I need to sharpen these chains before installing them, and how should I tension them after putting one on?
These replacement chains are typically ready to install and use, so you should not need to sharpen them before first use. After installation, adjust the tension so the chain sits snugly against the bar but can still be pulled around by hand with a gloved hand, then recheck tension after the first few minutes of cutting.
Q: Since this is a 2PC 16 Inch Chainsaw Chain Replacement set, can I swap between the two chains for maintenance?
Yes, rotating between the two chains is a good way to reduce wear on a single chain and keep cutting performance more consistent. Just keep both chains properly oiled, clean out the bar groove when swapping, and inspect for stretching or dull cutters before each use.
