Descripción General
Designed as a drop-in replacement for Remington 091375-02S 114736-01S Chainsaw models, this chain restores your saw’s cutting ability to like-new condition. Ships as a 2-piece set, giving you a ready spare. Reemplazar una cadena estirada o dañada restaura tanto la velocidad de corte como la seguridad del operador.
Especificaciones Principales
- Largo de la barra: 16”
- Cantidad: 2 cadenas por paquete
Compatibilidad
Fits Remington 091375-02S 114736-01S Chainsaw as a direct replacement for the factory chain. Consulte el manual del propietario o las marcas de la cadena existente para verificar el paso, calibre y número de eslabones de transmisión antes de realizar el pedido.
Notas de Instalación
Apague la motosierra y retire su fuente de alimentación antes de realizar el servicio. Destornille la tapa de la barra, afloje el tensor y retire la cadena vieja. Dirija la cadena nueva alrededor del tambor de embrague y hacia la ranura de la barra, asegurándose de que los eslabones de transmisión se asienten correctamente. Apriete el tensor hasta que la cadena encaje bien contra la parte inferior de la barra pero aún se desliza libremente, luego ejecute la sierra brevemente al ralentí para confirmar un seguimiento uniforme.
Preguntas Comunes
P: Will this 2-pack 16-inch chain fit my Remington 091375-02S or 114736-01S chainsaw without modification?
Yes, this replacement chain set is made for Remington 091375-02S and 114736-01S chainsaws with a 16-inch bar. As long as your saw is using the original 16-inch setup, these chains should install normally on the existing bar and sprocket.
P: Necesito afilar estas cadenas antes de instalarlas, and how should I tension them after putting one on?
These replacement chains are typically ready to install and use, so you should not need to sharpen them before first use. After installation, adjust the tension so the chain sits snugly against the bar but can still be pulled around by hand with a gloved hand, then recheck tension after the first few minutes of cutting.
P: Since this is a 2PC 16 Inch Chainsaw Chain Replacement set, can I swap between the two chains for maintenance?
Yes, rotating between the two chains is a good way to reduce wear on a single chain and keep cutting performance more consistent. Just keep both chains properly oiled, clean out the bar groove when swapping, and inspect for stretching or dull cutters before each use.
