Overview
Built to OEM specifications for WORX WG309 pole saws, this aftermarket chain is a cost-effective way to maintain cutting performance. Keeping a spare chain on hand means less downtime during jobs, and swapping a dull chain takes just minutes.
Key specifications
- Bar length: 10”
Compatibility
This chain is designed to fit WORX WG309. Always confirm your saw’s model number and bar length before ordering to ensure proper fit.
Installation notes
Disconnect the battery or unplug the pole saw before beginning any chain work. Remove the bar cover, take off the spent chain, and lay the new one into the bar groove with teeth oriented in the correct cutting direction. After reattaching the cover, set the chain tension so there is slight play but no sag under the bar. Run the saw briefly and recheck tension after the chain seats itself.
Common questions
Q: Will this 10 inch pole saw chain fit my WORX WG309, or is it only for certain versions?
Yes, this chain is made to fit the WORX WG309 that uses a 10-inch bar. If your saw is a WG309 with the original 10-inch setup, it should be the correct replacement chain, but it’s still a good idea to confirm your bar length matches before installing.
Q: Do I need any special tools to install this replacement chain on my WORX WG309?
You typically only need the standard bar cover access and chain tension adjustment on the saw, so no special tools are usually required beyond what you’d normally use for your WG309. Make sure the cutters are facing the correct direction on the top of the bar, then tension the chain so it sits snugly but still pulls around by hand.
Q: How often should I sharpen or replace this 10 inch pole saw chain on a WG309?
That depends on how often you cut and whether you’re hitting dirty wood or small debris, but you’ll usually notice it’s time when the saw starts cutting slowly or throws fine dust instead of chips. Keep the chain properly oiled and tensioned, and sharpen it as needed to extend its life before replacement becomes necessary.
