Overview
Built to OEM specifications for Worx WG349.9 WG349 Polesaw pole saws, this aftermarket chain is a cost-effective way to maintain cutting performance. Bundled as 2 chains, giving you a ready spare. A worn chain strains the motor and increases kickback risk, so timely replacement keeps your saw running safely and efficiently.
Key specifications
- Bar length: 8”
- Quantity: 2 chains per pack
Compatibility
Engineered for direct compatibility with Worx WG349.9 WG349 Polesaw. Verify your specific model number and existing chain dimensions before purchasing.
Installation notes
Disconnect the battery or unplug the pole saw before beginning any chain work. Remove the bar cover, take off the spent chain, and lay the new one into the bar groove with teeth oriented in the correct cutting direction. After reattaching the cover, set the chain tension so there is slight play but no sag under the bar. Run the saw briefly and recheck tension after the chain seats itself.
Common questions
Q: Will this 2PC 8 inch pole saw chain fit both the Worx WG349 and WG349.9 polesaw?
Yes, this chain is made for the Worx WG349 and WG349.9 polesaw models with an 8-inch bar. If your saw uses the original 8-inch setup, these replacement chains should fit properly.
Q: How do I know if the chain is installed correctly on my Worx WG349?
Make sure the cutting teeth on the top of the bar are facing forward toward the tip of the bar. After installation, adjust the tension so the chain sits snugly against the bar but can still be pulled around by hand with gloves.
Q: How often should I sharpen or replace this 8 inch pole saw chain?
That depends on what you’re cutting and whether the chain has contacted dirt or bark with embedded grit. If the saw starts producing fine dust instead of chips or you have to force the cut, it’s time to sharpen the chain or replace it if the cutters are badly worn or damaged.
