Overview
Available as a 2-pack, this chain is a direct replacement for RYOBI RY3716 / RY40550 models. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 16”
- Quantity: 2 chains per pack
Compatibility
This replacement chain works with RYOBI RY3716 / RY40550. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Begin by shutting off the saw and disconnecting the power source. Loosen the bar-mounting fasteners and remove the side cover to access the chain. Slide the worn chain off, seat the replacement around the sprocket and into the bar groove with cutters pointing in the direction of rotation. Tighten the tensioning screw until there is slight play but no droop, then secure the cover.
Common questions
Q: Will this 2-pack 16 inch chainsaw chain fit both my RYOBI RY3716 gas saw and my RY40550 battery saw?
Yes, this chain is made for 16 inch setups and is listed as compatible with both the RYOBI RY3716 and RY40550. As long as your saw is still using the stock 16 inch bar, these chains are the correct replacement option.
Q: Do I need to adjust chain tension differently when installing this on my RY3716 or RY40550?
After installing, tighten the chain so it sits snug against the bar but can still be pulled around by hand with gloves on. Check tension again after the first few cuts, because a new chain will usually stretch slightly as it seats into the bar and drive system.
Q: How do I know when to sharpen or replace one of these 16 inch chains on my RYOBI saw?
If the saw starts making fine dust instead of chips, pulls to one side, or requires extra pressure to cut, the chain likely needs sharpening. Replace the chain if the cutters are heavily worn, the chain has damaged or cracked links, or it no longer holds a proper edge after sharpening.
