Overview
Sold as a 2-pack, this chain is a direct replacement for 2727-20 models. Swapping in a new chain is the single most effective maintenance step to keep your saw performing at its best.
Key specifications
- Bar length: 16”
- Quantity: 2 chains per pack
Compatibility
Manufactured to fit 2727-20 without modification. Cross-reference your saw’s model number with the product listing to confirm compatibility.
Installation notes
Disconnect the spark plug wire or remove the battery before changing a chainsaw chain. Remove the bar cover, release bar tension, and take off the old chain. Place the new chain into the bar groove with the cutting teeth facing forward on top. Reinstall the cover, adjust chain tension until snug, and test by pulling the chain around the bar by hand. Re-check tension after a few minutes of use.
Common questions
Q: Will this 2-pack 16 inch chainsaw chain fit my Milwaukee 2727-20, or do I need any other specs besides the bar length?
Yes, this chain is intended for the Milwaukee 2727-20 when you are running the 16-inch bar setup. It’s always smart to confirm the chain specs stamped on your current bar or in your saw manual so the pitch, gauge, and drive link count match your exact bar configuration.
Q: I’m replacing the chain on my 2727-20 for the first time—do I need to sharpen these first or install them right out of the package?
These replacement chains should be installed and used right out of the package; no pre-sharpening is normally needed. After installation, make sure the cutting teeth face the correct direction on the top of the bar, set the chain tension so it snaps back into place, and verify bar oil is flowing before making full cuts.
Q: How often should I tighten or maintain these 16 inch chains during use on a 2727-20?
A new chain will usually stretch a bit during the first few cuts, so check tension frequently at the start of use. Keep the chain properly oiled, touch up the cutters when you notice slower cutting or fine dust instead of chips, and inspect the bar groove and drive sprocket regularly to help both chains in the 2-pack last longer.
