Overview
Ships as a 2-piece set, this chain is a direct replacement for Husqvarna 225i Chainsaw models. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 14”
- Quantity: 2 chains per pack
Compatibility
Manufactured to fit Husqvarna 225i Chainsaw without modification. Always confirm your saw’s model number and bar length before ordering to ensure proper fit.
Installation notes
Turn off the chainsaw and remove its power source before servicing. Unscrew the bar cover, back off the tensioner, and pull the old chain free. Route the fresh chain around the clutch drum and into the bar groove, making sure the drive links seat properly. Tighten the tensioner until the chain snaps snugly against the underside of the bar but still slides freely, then run the saw briefly at idle to confirm smooth tracking.
Common questions
Q: Will this 2-pack 14 inch chainsaw chain fit my Husqvarna 225i with the stock 14” bar?
Yes, this chain is intended for the Husqvarna 225i running the standard 14-inch bar. If your saw is still using the factory bar setup, it should be a direct replacement, but it’s always smart to confirm the chain specs stamped on your current bar before installation.
Q: Do I need to do anything special when installing one of these chains on my Husqvarna 225i?
Make sure the chain teeth are facing the correct cutting direction on the top of the bar, then set the tension so the chain sits snugly but can still be pulled around by hand with gloves on. After the first few cuts, recheck tension because a new chain will usually stretch slightly as it seats in.
Q: How often should I sharpen and maintain this 14 inch chain for the 225i?
Touch up the cutters whenever you notice the saw making fine dust instead of chips or if it starts pulling to one side in the cut. Keep the chain properly tensioned, make sure the bar oil is flowing, and inspect the drive links and cutters regularly since good lubrication and timely sharpening will extend chain life.
