Overview
Bundled as 2 chains, this chain is a direct replacement for WORX WG384 / WG384.9 models. Fresh chains cut cleaner, reduce vibration, and put less stress on the saw’s drive system.
Key specifications
- Bar length: 14”
- Quantity: 2 chains per pack
Compatibility
Manufactured to fit WORX WG384 / WG384.9 without modification. Verify your specific model number and existing chain dimensions before purchasing.
Installation notes
Begin by shutting off the saw and disconnecting the power source. Loosen the bar-mounting fasteners and remove the side cover to access the chain. Slide the worn chain off, seat the replacement around the sprocket and into the bar groove with cutters pointing in the direction of rotation. Tighten the tensioning screw until there is slight play but no droop, then secure the cover.
Common questions
Q: Will this 2-pack 14” chainsaw chain fit my WORX WG384.9, or is it only for the WG384?
Yes, this set is made for both the WORX WG384 and WG384.9 using a 14-inch bar. As long as your saw is one of those two models and still has the stock 14” setup, these chains are the correct replacement option.
Q: Do I need any special tools to install this 14” chain on my WORX WG384?
You typically just need to loosen the side cover, remove the old chain, and seat the new chain around the bar and drive sprocket. Make sure the cutting teeth face forward on the top of the bar, then adjust chain tension so it’s snug but still moves freely by hand.
Q: How often should I sharpen or replace these chains on a WORX 14” saw?
That depends on what you’re cutting, but if the saw starts making fine dust instead of chips or you have to force it through the wood, the chain likely needs sharpening. Keep the chain properly tensioned and the bar oil filled, and replace the chain when the cutters are worn down or sharpening no longer restores good cutting performance.
