Overview
Comes in a convenient 2-pack, this chain is a direct replacement for Worx WG350 / WG350.9 Chainsaw models. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 12”
- Quantity: 2 chains per pack
Compatibility
Manufactured to fit Worx WG350 / WG350.9 Chainsaw without modification. Cross-reference your saw’s model number with the product listing to confirm compatibility.
Installation notes
Turn off the chainsaw and remove its power source before servicing. Unscrew the bar cover, back off the tensioner, and pull the old chain free. Route the fresh chain around the clutch drum and into the bar groove, making sure the drive links seat properly. Tighten the tensioner until the chain snaps snugly against the underside of the bar but still slides freely, then run the saw briefly at idle to confirm smooth tracking.
Common questions
Q: Will this 2-pack 12 inch chain fit my Worx WG350.9, or is it only for the WG350?
Yes, this chain set is made for both the Worx WG350 and WG350.9 using a 12 inch bar. As long as your saw is one of those models and still has the original 12 inch setup, these chains should fit correctly.
Q: Do I need any special tools to install these chains on my Worx WG350 chainsaw?
No special tools are usually needed for a standard chain swap on the WG350 or WG350.9, but you should loosen the side cover, seat the chain correctly on the bar and sprocket, and then set the proper tension before use. Make sure the cutting teeth face the correct direction on the top of the bar, and recheck tension after the first few cuts since a new chain can stretch slightly.
Q: How often should I sharpen and oil these 12 inch chains for the Worx WG350?
Keep the chain well oiled every time you run the saw, since a dry chain will wear quickly and cut poorly. Sharpen it whenever you notice it pulling fine dust instead of chips, requiring extra pressure to cut, or cutting crooked, and inspect the chain regularly for damaged or dull cutters.
