Overview
Designed as a drop-in replacement for Stihl 71PM3 64/71 PM3 64 models, this chain restores your saw’s cutting ability to like-new condition. Comes in a convenient 2-pack, giving you a ready spare. Chains wear down over time from regular use, and a fresh chain cuts faster and safer than a dull one.
Key specifications
- Bar length: 12”
- Quantity: 2 chains per pack
Compatibility
Manufactured to fit Stihl 71PM3 64/71 PM3 64 without modification. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Disconnect the spark plug wire or remove the battery before changing a chainsaw chain. Remove the bar cover, release bar tension, and take off the old chain. Place the new chain into the bar groove with the cutting teeth facing forward on top. Reinstall the cover, adjust chain tension until snug, and test by pulling the chain around the bar by hand. Re-check tension after a few minutes of use.
Common questions
Q: Will this 2-pack 12 inch chain fit my Stihl saw that uses a 71PM3 64 chain?
Yes. This replacement set is made to match Stihl 71PM3 64 / 71 PM3 64 spec, so it fits saws that call for that exact 12-inch chain setup. The most important thing is to confirm your current chain is marked 71PM3 64 or has the same drive link count and bar size.
Q: Are these chains ready to install on a 12 inch bar, or do I need to shorten them first?
They are intended for direct installation on a 12-inch bar that uses the Stihl 71PM3 64 configuration, so no shortening should be needed. Before installing, make sure the chain direction is correct, seat it fully in the bar groove, and adjust tension so the chain snaps back into place without sagging under the bar.
Q: What maintenance should I do to keep these 12 inch saw chains cutting well and lasting longer?
Keep the chain properly tensioned, maintain bar oil flow, and touch up the cutters with the correct file before they get badly dull. It also helps to clean the bar groove and check the drive links regularly, especially after cutting dirty or resin-heavy wood, since buildup and heat are common causes of premature wear.
