Overview
Built to OEM specifications for RYOBI RY40506BTL / RY40560 / RYPRN33 pole saws, this aftermarket chain is a cost-effective way to maintain cutting performance. Ships as a 2-piece set, giving you a ready spare. Keeping a spare chain on hand means less downtime during jobs, and swapping a dull chain takes just minutes.
Key specifications
- Bar length: 10”
- Quantity: 2 chains per pack
Compatibility
Fits RYOBI RY40506BTL / RY40560 / RYPRN33 as a direct replacement for the factory chain. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Disconnect the battery or unplug the pole saw before beginning any chain work. Remove the bar cover, take off the spent chain, and lay the new one into the bar groove with teeth oriented in the correct cutting direction. After reattaching the cover, set the chain tension so there is slight play but no sag under the bar. Run the saw briefly and recheck tension after the chain seats itself.
Common questions
Q: Will this 2-pack 10 inch pole saw chain fit my RYOBI RY40560, or is it only for the RY40506BTL and RYPRN33?
Yes, this chain is made to fit the 10-inch bar used on the RYOBI RY40506BTL, RY40560, and RYPRN33. If your saw is using the factory 10-inch bar for one of those models, this replacement chain is the correct fit.
Q: Do I need any special tools to install this 10 inch chain on my RYOBI RY40506BTL?
You typically just need to loosen the side cover, remove the old chain, and seat the new chain around the bar and drive sprocket with the cutting edges facing the correct direction. After installation, adjust the chain tension so it sits snug on the bar but can still be pulled around by hand, then recheck tension after the first few cuts.
Q: How often should I sharpen or replace the chain on my RYPRN33 10-inch pole saw?
That depends on what you’re cutting, but if the saw starts producing fine dust instead of chips, pulls to one side, or needs extra pressure, the chain likely needs sharpening. Keep the chain properly oiled and tensioned, and replace it when the cutters are worn down or sharpening no longer restores good cutting performance.
