Overview
This aftermarket pole saw chain is a direct-fit replacement for 49-16-2720 pole saws. Packaged as a set of 2, giving you a ready spare. A sharp chain means less effort, cleaner cuts, and safer operation compared to pushing through wood with worn teeth.
Key specifications
- Bar length: 10”
- Quantity: 2 chains per pack
Compatibility
This replacement chain works with 49-16-2720. Double-check your model number against the listing to ensure a correct match before installation.
Installation notes
Start by powering down the pole saw and removing the battery or disconnecting the cord. Take off the side cover and bar, then remove the dull chain. When mounting the fresh chain, confirm the teeth point forward along the top edge of the bar. Tighten the tensioning screw until the chain sits firmly in the groove without binding, then hand-test rotation before powering on.
Common questions
Q: Will this 2-pack 10 inch pole saw chain fit the Milwaukee 49-16-2720 bar, or is it only for certain pole saw setups?
Yes, this chain is made to fit the 49-16-2720 10-inch bar, so it’s the correct replacement if that’s the bar number stamped on your setup. As long as you’re running the matching 10-inch bar, this chain should install and tension normally without modification.
Q: I have a 10-inch pole saw, but my current chain is worn out. Do I need to match the bar part number 49-16-2720 exactly, or is the 10 inch length enough?
The 10-inch length alone is not always enough, because chain fit also depends on the exact bar design and drive link setup. For best results, confirm your bar is the 49-16-2720 model before ordering or installing, since this replacement chain is specifically listed for that bar.
Q: What’s the best way to install and maintain this 10 inch pole saw chain so it cuts properly and doesn’t wear out too fast?
When installing, make sure the cutting teeth face the correct direction on the top side of the bar, then set chain tension so it sits snugly but still moves freely by hand. Keep the chain oiled, check tension again after the first few cuts, and sharpen or replace it if you notice it pulling to one side or making fine dust instead of chips.
