Overview
Available as a 2-pack, this chain is a direct replacement for CRAFTSMAN CMECSP610 models. Keeping a spare chain on hand means less downtime during jobs, and swapping a dull chain takes just minutes.
Key specifications
- Bar length: 10”
- Quantity: 2 chains per pack
Compatibility
This chain is designed to fit CRAFTSMAN CMECSP610. Always confirm your saw’s model number and bar length before ordering to ensure proper fit.
Installation notes
Turn off the chainsaw and remove its power source before servicing. Unscrew the bar cover, back off the tensioner, and pull the old chain free. Route the fresh chain around the clutch drum and into the bar groove, making sure the drive links seat properly. Tighten the tensioner until the chain snaps snugly against the underside of the bar but still slides freely, then run the saw briefly at idle to confirm smooth tracking.
Common questions
Q: Will this 2-pack 10 inch chainsaw chain fit my CRAFTSMAN CMECSP610, or do I need to match anything besides the 10 inch bar length?
Yes, this chain is made for the CRAFTSMAN CMECSP610 with a 10 inch bar, so it is the correct replacement for that saw model. It’s still a good idea to compare the old chain’s markings and make sure the bar and drive components are original, especially if the saw has had parts replaced before.
Q: Do I need to do anything special when installing one of these chains on my CRAFTSMAN CMECSP610?
After installing the chain, make sure the cutting teeth on the top of the bar are facing forward and then adjust the tension so the chain sits snugly but can still be pulled around by hand with gloves on. Recheck the tension after the first few cuts, because a new chain can stretch slightly during initial use.
Q: Since this comes with 2 chains, how should I maintain them so they last longer on my 10 inch CRAFTSMAN saw?
Keep the chain properly tensioned, make sure the bar oil system is working, and clean sawdust out of the bar groove and around the drive area regularly. Rotating between the two chains and sharpening them before they get overly dull will help reduce wear on both the chain and the bar.
