Overview
Packaged as a set of 2, this chain is a direct replacement for WORX WG303 WG303.1 Chainsaw models. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 16”
- Quantity: 2 chains per pack
Compatibility
This replacement chain works with WORX WG303 WG303.1 Chainsaw. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Power down the saw and disconnect the battery or spark plug lead. Remove the side cover and release bar tension. Take the old chain off the bar and sprocket, then thread the new chain into the bar groove, confirming the cutting edges face forward on the top rail. Set the tension so the chain pulls freely without sagging away from the bar, and do a brief test run to verify everything tracks correctly.
Common questions
Q: Will this 16-inch chain fit my WORX WG303.1 exactly, or do I need to modify anything?
Yes, this chain is made to fit the WORX WG303 and WG303.1 chainsaws with a 16-inch bar. If your saw still has the original 16-inch setup, it should install as a direct replacement without any modification.
Q: Does this 2-pack include everything I need, or is it just the replacement chains for my WG303?
This set includes 2 replacement 16-inch chains only, not the guide bar or other saw parts. It’s a good option if your current bar is still in good condition and you just need fresh chains for your WORX WG303 or WG303.1.
Q: What’s the best way to install and maintain these chains on a WORX WG303 chainsaw?
When installing, make sure the cutting teeth face the correct direction on the top side of the bar and set the chain tension so it sits snugly but still moves freely by hand. After the first few cuts, recheck tension because a new chain can stretch slightly, and keep the bar oil filled to reduce wear on both the chain and bar.
