Overview
This replacement pruning chain matches OEM specifications for Greenworks CS24L210 / CS24L02 models, making it a straightforward swap for a worn or damaged chain. Keeping a spare chain on hand means less downtime during jobs, and swapping a dull chain takes just minutes.
Key specifications
- Bar length: 6”
Compatibility
Fits Greenworks CS24L210 / CS24L02 as a direct replacement for the factory chain. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Remove the battery before servicing a pruning saw chain. Release the chain cover, lift off the old chain, and place the replacement into the bar groove with cutters facing forward on the top rail. Reattach the cover and tension the chain until snug with no visible sag. Test by pulling the chain around the bar by hand to verify smooth movement.
Common questions
Q: Will this 6 inch pruning chainsaw chain fit both the Greenworks CS24L210 and CS24L02, or are those saws using different chain sizes?
Yes, this chain is made for the 6 inch bar setup used on both the Greenworks CS24L210 and CS24L02. As long as your saw still has the original 6 inch pruning bar, this replacement chain is the correct fit for those two models.
Q: Do I need any special tools to install this chain on my Greenworks CS24L210, and how tight should it be?
You typically just need to open the side cover, seat the chain around the sprocket and 6 inch bar, then adjust the tension before tightening everything back down. Set it so the chain sits snugly against the bar but can still be pulled around by hand with a gloved finger; if it’s overly tight, it can wear the bar and motor faster.
Q: How often should I sharpen or replace this 6 inch pruning chain on a Greenworks CS24L02?
That depends on what you’re cutting, but if you notice the saw making fine dust instead of chips, pulling to one side, or needing extra pressure, the chain likely needs sharpening. Replace it when the cutters are worn down, the chain has damaged or cracked links, or it no longer holds an edge well after sharpening.
