5 Inch Chainsaw Chain

Name: 5 Inch Chainsaw Chain
Brand: OPULADUO
SKU: B0CLGLXMLT
Price: 17.98 USD
Availability: InStock
Rating: 4.1 (1 reviews)

Overview

A direct-fit replacement chain for Sun Joe 24V-HCS-LTE Handheld Chainsaw mini saws, ready for pruning and light-duty cutting tasks. Chains wear down over time from regular use, and a fresh chain cuts faster and safer than a dull one.

Key specifications

Bar length: 5”

Compatibility

Manufactured to fit Sun Joe 24V-HCS-LTE Handheld Chainsaw without modification. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.

Installation notes

Always disconnect power before swapping the chain. On most pruning saws, a thumbscrew or tool-free knob releases the bar cover. Remove the worn chain, position the new one with teeth oriented in the cutting direction, and reassemble. Adjust tension so the chain is firm against the bar but still rotates freely by hand.

Common questions

Q: Will this 5 inch chainsaw chain fit my Sun Joe 24V-HCS-LTE handheld chainsaw, or is it only for certain bar sizes?

Yes, this chain is made for the Sun Joe 24V-HCS-LTE and matches the 5 inch bar used on that handheld chainsaw. If your saw is the 24V-HCS-LTE with the original 5 inch bar, this is the correct replacement chain size.

Q: How do I install this replacement chain on the Sun Joe 24V-HCS-LTE, and how tight should it be?

When installing it, make sure the cutting teeth are facing the correct direction along the top of the bar, then seat the chain fully in the bar groove before adjusting tension. A properly adjusted chain should sit snugly against the bar but still pull around by hand with light resistance once the saw is powered off.

Q: Do I need to oil or sharpen this 5 inch chain regularly on the Sun Joe 24V-HCS-LTE?

Yes, even on a small 5 inch handheld chainsaw, the chain should be kept clean, lightly lubricated as required by your saw’s design, and sharpened when cutting starts to slow or pull to one side. Regular maintenance helps reduce strain on the motor and gives you smoother, safer cuts.

Before you buy — how to verify fitment

Find the bar stamp. Look on the side of your current guide bar for the pitch, gauge, and drive-link count.
Match all three numbers. Pitch (1/4), gauge (.043"), and drive links (28DL) must all match.
Check bar length. Measure cutting length from the tip to where the bar enters the saw body — this should match 5".
Confirm your saw model against the compatibility list above. If your model isn't listed, the chain may still fit if pitch/gauge/DL match.

Frequently asked questions

How do I know this chain fits my saw?

Match three numbers: pitch, gauge, and drive-link count. All three must match the stamp on your current bar. If even one is off, the chain won't fit safely.

How do I measure pitch and gauge?

Pitch is the distance between any three consecutive rivets, divided by two. Gauge is the thickness of the drive links — measure with a caliper or check the bar stamp. Our guide covers both in detail.

How long does a replacement chain last?

With proper tension and occasional sharpening, an aftermarket chain lasts 3–5 cords of firewood or about 5 hours of active cutting — roughly the same as OEM.

Can I sharpen this chain or is it single-use?

Absolutely sharpen it. A quality replacement chain can be sharpened 3–5 times before the cutters are too short. Keep a round file matched to the cutter diameter.

Where to buy

This part is available through Amazon with free returns on most orders. We've verified the fitment listed above — check the live listing for current price, stock, and delivery options.

Affiliate disclosure: we may earn a commission when you purchase through this link, at no extra cost to you.