Overview
Available as a 2-pack, this chain is a direct replacement for RYOBI P4360 RY43160 P4361 models. Swapping in a new chain is the single most effective maintenance step to keep your saw performing at its best.
Key specifications
- Bar length: 8”
- Pitch: 3/8”
- Gauge: .043”
- Drive links: 33 drive links
- Quantity: 2 chains per pack
Compatibility
This replacement chain works with RYOBI P4360 RY43160 P4361. Cross-reference your saw’s model number with the product listing to confirm compatibility.
Installation notes
Begin by shutting off the saw and disconnecting the power source. Loosen the bar-mounting fasteners and remove the side cover to access the chain. Slide the worn chain off, seat the replacement around the sprocket and into the bar groove with cutters pointing in the direction of rotation. Tighten the tensioning screw until there is slight play but no droop, then secure the cover.
Common questions
Q: Will this 2-pack of 8 inch replacement chains fit my RYOBI P4360 pole saw, or is it only for the RY43160 and P4361?
Yes, these chains are made to fit the RYOBI P4360, RY43160, and P4361 models listed. They are sized for an 8-inch bar and use a 3/8 pitch, so they match the saws specified for that setup.
Q: Do I need any special steps to install this 8 inch 3/8 pitch chain on my RYOBI P4361?
When installing it, make sure the saw is powered off and the chain teeth on the top of the bar are pointing forward toward the bar tip. After mounting, adjust the tension so the chain sits snugly against the bar but can still be pulled around by hand, then recheck tension after the first few cuts.
Q: How often should I sharpen or replace these chains on my RY43160, and do they need bar oil?
Yes, you should keep the chain properly oiled during use to reduce heat and premature wear. Sharpen it when cutting starts to feel slow or the saw throws fine dust instead of chips, and replace the chain if the cutters are badly worn, damaged, or can no longer be sharpened evenly.
