Overview
Sold as a 2-pack, this chain is a direct replacement for Dewalt DCPS620B DCPS620M1 Chainsaw models. Chains wear down over time from regular use, and a fresh chain cuts faster and safer than a dull one.
Key specifications
- Bar length: 8”
- Quantity: 2 chains per pack
Compatibility
Engineered for direct compatibility with Dewalt DCPS620B DCPS620M1 Chainsaw. Always confirm your saw’s model number and bar length before ordering to ensure proper fit.
Installation notes
Start by powering down the pole saw and removing the battery or disconnecting the cord. Take off the side cover and bar, then remove the dull chain. When mounting the fresh chain, confirm the teeth point forward along the top edge of the bar. Tighten the tensioning screw until the chain sits firmly in the groove without binding, then hand-test rotation before powering on.
Common questions
Q: Will this 2-pack 8-inch pole saw chain fit both the DeWalt DCPS620B and the DCPS620M1?
Yes, this chain is made for the 8-inch bar used on both the DeWalt DCPS620B and DCPS620M1 pole saws. As long as your saw is still using the original 8-inch bar size, these replacement chains should fit correctly.
Q: Do I need to sharpen these chains before installing them on my DeWalt DCPS620B pole saw?
No, they should be ready to install and use right out of the package. Before cutting, make sure the chain is installed in the correct direction, properly tensioned, and that your bar oil reservoir is filled so the chain stays lubricated.
Q: How tight should I set the chain on my 8-inch DeWalt pole saw bar after installation?
Set the chain so it sits snugly against the bar but can still be pulled around by hand with a gloved hand. After a few minutes of use, check the tension again, because a new chain can stretch slightly during the initial break-in period.
