Overview
This aftermarket pruning chain is engineered as a direct replacement for Makita XCU14Z pruning saws. Comes in a convenient 2-pack, giving you a ready spare. Swapping in a new chain is the single most effective maintenance step to keep your saw performing at its best.
Key specifications
- Bar length: 6”
- Quantity: 2 chains per pack
Compatibility
Manufactured to fit Makita XCU14Z without modification. Cross-reference your saw’s model number with the product listing to confirm compatibility.
Installation notes
Always disconnect power before swapping the chain. On most pruning saws, a thumbscrew or tool-free knob releases the bar cover. Remove the worn chain, position the new one with teeth oriented in the cutting direction, and reassemble. Adjust tension so the chain is firm against the bar but still rotates freely by hand.
Common questions
Q: Will this 2PC 6” pruning saw chain fit my Makita XCU14Z, or do I need to match anything besides the 6-inch bar length?
Yes, this chain set is made for the Makita XCU14Z with a 6” bar, so it is the correct fit for that model. The main thing is to confirm you are still using the original 6” pruning bar, since chain fit depends on the bar size and the saw model together.
Q: I’m installing this on my Makita XCU14Z for the first time—do I need to tension the new chain differently after I start using it?
Yes, a new pruning chain will usually stretch slightly during the first few cuts, so check the tension again after a short break-in period. On the XCU14Z, the chain should sit snug on the 6” bar but still pull around by hand with gloves on, and you should keep the cutters oiled during use.
Q: Are both chains in this 2-pack meant for pruning clean wood, and how do I keep them cutting well on the 6” Makita XCU14Z?
Yes, these 6” chains are intended for pruning and general clean wood cutting on the Makita XCU14Z. To keep them cutting properly, clean out sawdust after use, maintain correct chain tension, and touch up the cutters regularly or replace the chain if it starts pulling to one side or producing fine dust instead of chips.
