Overview
Designed as a drop-in replacement for DEWALT DCCS674X2 models, this chain restores your saw’s cutting ability to like-new condition. Sold as a 2-pack, giving you a ready spare. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 14”
- Quantity: 2 chains per pack
Compatibility
This chain is designed to fit DEWALT DCCS674X2. Double-check your model number against the listing to ensure a correct match before installation.
Installation notes
Disconnect the spark plug wire or remove the battery before changing a chainsaw chain. Remove the bar cover, release bar tension, and take off the old chain. Place the new chain into the bar groove with the cutting teeth facing forward on top. Reinstall the cover, adjust chain tension until snug, and test by pulling the chain around the bar by hand. Re-check tension after a few minutes of use.
Common questions
Q: Will this 2-pack of 14” chains fit my DEWALT DCCS674X2 exactly, or do I need to match anything else besides the bar length?
Yes, these chains are made for the DEWALT DCCS674X2 with a 14” bar, so they’re intended to fit that saw correctly. It’s still smart to confirm your existing chain specs on the bar or in the manual, since chain length and drive link count need to match the original setup, not just the 14” bar length.
Q: I’m replacing the chain on my DEWALT DCCS674X2 for the first time—do I need to do anything special after installing one of these 14” chains?
After installation, set the chain tension so it sits snugly on the bar but can still be pulled around by hand with gloves on. Run the saw briefly, then recheck tension because a new chain will usually stretch slightly during the first few cuts, and make sure the bar oil reservoir is full before use.
Q: How often should I sharpen or maintain these 14” chains on a DEWALT DCCS674X2 if I use the saw for limbing and small firewood cuts?
For typical limbing and light firewood work, sharpen the chain whenever you notice it pulling to one side, producing fine dust instead of chips, or requiring extra pressure to cut. Also keep the chain properly tensioned and the bar groove clean, because good lubrication and regular cleaning will help both chains in the 2-pack last longer.
