Overview
Comes in a convenient 2-pack, this chain is a direct replacement for Kobalt KPS 1081-06 / KPS 1180-06 80V models. Replacing a stretched or damaged chain restores both cutting speed and operator safety.
Key specifications
- Bar length: 10”
- Quantity: 2 chains per pack
Compatibility
Engineered for direct compatibility with Kobalt KPS 1081-06 / KPS 1180-06 80V. Check your owner’s manual or the existing chain’s markings to verify pitch, gauge, and drive link count before ordering.
Installation notes
Start by powering down the pole saw and removing the battery or disconnecting the cord. Take off the side cover and bar, then remove the dull chain. When mounting the fresh chain, confirm the teeth point forward along the top edge of the bar. Tighten the tensioning screw until the chain sits firmly in the groove without binding, then hand-test rotation before powering on.
Common questions
Q: Will this 2-pack 10 inch pole saw chain fit both the Kobalt KPS 1081-06 and KPS 1180-06 80V pole saws?
Yes, this chain is made for the 10-inch bar used on the Kobalt KPS 1081-06 and KPS 1180-06 80V pole saws. If your saw still has the original 10-inch bar, these replacement chains should fit correctly.
Q: Do I need to adjust chain tension after installing one of these on my Kobalt 80V pole saw?
Yes, you should always check and set the chain tension after installation, then recheck it after the first few cuts. A properly tensioned chain should sit snug on the 10-inch bar but still pull around by hand with gloves without binding.
Q: How often should I replace or maintain the 10 inch chain on my Kobalt KPS 1081-06 / KPS 1180-06?
Keep the chain clean, properly oiled, and sharpened regularly to maintain smooth cutting performance. Replace it when it no longer holds an edge well, shows damaged or missing cutters, or stretches to the point where proper tension can no longer be maintained.
