Opuladuo 2PC 16 Inch Chainsaw Chain for Craftsman CMECS600

16-inch replacement chain fitment for selected Craftsman saws

This Opuladuo 2-piece 16-inch chainsaw chain set is listed as a replacement for selected Craftsman chainsaws, including the Craftsman CMECS600, S165, S160, and CMXGSAMN4216. If you use one of those saws with a 16-inch bar, this product is intended as a direct replacement chain option.

Each package includes 2 pcs 16-inch chain, which is handy if you want a spare ready to go when the first chain gets dull.

Will this chain fit your saw?

The quickest starting point is your saw model. According to the original listing, this chain is for:

• Craftsman CMECS600
• Craftsman S165
• Craftsman S160
• Craftsman CMXGSAMN4216

It is also important to confirm the chain size details on your current setup before ordering. Even when a bar is 16 inches long, chains can still vary by:

• Pitch
• Gauge
• Drive-link count

To verify fitment, check these places:

• The bar stamp or printed markings on the guide bar
• Your owner’s manual
• The markings on the old chain packaging, if you still have it
• The existing chain, if its size information is marked

For this product page, the confirmed spec provided is bar length: 16”. The listing does not provide pitch, gauge, or drive-link count, so the best way to confirm fit is to match your existing chain’s specifications exactly. If your saw is one of the compatible models above and it is using the original 16-inch bar setup, this chain is designed for that application.

If your saw has had the bar replaced in the past, double-check carefully. A chainsaw model may accept different bar and chain combinations depending on what is currently installed.

Replacing the chain

Before you begin, unplug the saw or otherwise make sure it cannot start accidentally. Wear gloves when handling the old or new chain.

1. Loosen the side cover and remove it so you can access the bar and chain.
2. Release chain tension, then lift the old chain off the drive sprocket and guide bar.
3. Clean out sawdust and oil buildup around the bar groove, sprocket area, and side cover before installing the new chain.
4. Fit the new chain around the drive sprocket and along the bar, making sure the cutting teeth face the correct direction on the top side of the bar.
5. Reinstall the side cover and adjust chain tension until the chain sits snugly in the bar groove but still pulls around by hand.
6. After tightening everything, recheck tension again after a short test run, since a new chain can settle in quickly.

A chain that is too loose can derail. A chain that is too tight can wear the bar, sprocket, and motor faster.

Keeping it sharp

A sharp chain cuts faster, puts less strain on the saw, and is generally safer to use than a dull one.

• Keep the chain properly lubricated. Good chain oil flow helps reduce heat and premature wear.
• Touch up the cutters early instead of waiting until the chain is very dull. If the saw starts making fine dust instead of larger chips, it is usually time for sharpening.
• Avoid cutting into dirt, rocks, or fencing. Even brief contact with abrasive material can dull a chain very quickly.

Also keep an eye on chain tension during use, especially with a fresh chain. Minor retensioning after the first few cuts is normal.

FAQ

Will this fit a Craftsman CMECS600 with a 16-inch bar?

Yes, the listing specifically states this 16-inch replacement chain fits the Craftsman CMECS600. It is still smart to confirm the pitch, gauge, and drive-link count on your current bar and chain before ordering.

Does this package include one chain or two?

The listing states: Package Includes: 2Pcs 16-Inch Chain. That means you get two 16-inch replacement chains in the package.