Descripción General
This aftermarket chainsaw chain serves as a direct replacement for WORX WG305.1 WG305 chainsaws. Packaged as a set of 3, giving you a ready spare. Reemplazar una cadena estirada o dañada restaura tanto la velocidad de corte como la seguridad del operador.
Especificaciones Principales
- Largo de la barra: 14”
- Pitch: 3/8”
- Gauge: .050”
- Drive links: 52 drive links
- Cantidad: 3 cadenas por paquete
Compatibilidad
Fits WORX WG305.1 WG305 as a direct replacement for the factory chain. Consulte el manual del propietario o las marcas de la cadena existente para verificar el paso, calibre y número de eslabones de transmisión antes de realizar el pedido.
Notas de Instalación
Apague la motosierra y retire su fuente de alimentación antes de realizar el servicio. Destornille la tapa de la barra, afloje el tensor y retire la cadena vieja. Dirija la cadena nueva alrededor del tambor de embrague y hacia la ranura de la barra, asegurándose de que los eslabones de transmisión se asienten correctamente. Apriete el tensor hasta que la cadena encaje bien contra la parte inferior de la barra pero aún se desliza libremente, luego ejecute la sierra brevemente al ralentí para confirmar un seguimiento uniforme.
Preguntas Comunes
P: Will this 14-inch 3/8 pitch chain fit my WORX WG305.1, or is it only for the WG305?
Yes, this chain is made to fit both the WORX WG305.1 and WG305 when using the 14-inch bar. As long as your saw still has the original 14-inch setup and matches the listed 3/8 pitch, this replacement chain is the correct fit.
P: I have a WORX WG305 with a 14-inch bar—do I need to do anything special when installing one of these replacement chains?
When installing, make sure the cutting teeth on the top side of the bar face forward toward the tip of the bar. After mounting, set the chain tension so it sits snug against the bar but can still be pulled around by hand, then recheck tension after the first few cuts since new chains can stretch slightly.
P: Since this is a 3-pack of 14-inch chains, how should I maintain them so they last longer on my WORX WG305.1?
Keep each chain properly sharpened and make sure the bar oil reservoir is always filled before cutting. It also helps to rotate between the three chains, clean sawdust from the bar groove and drive area, and inspect for dull or damaged cutters after hitting dirty wood or debris.
